Fault 35 on my ND5 :-(

Posted by: solwisesteve on 06 December 2014

Went into the living room this am to see this written on the front of the ND5 display...

Fault 35

DSPDAC Reg4(W) Fail

Switched it off/on and the fault cleared.

What's a Fault 35 then... something that's going to come back?

Worry about it or forget it?

Cheers

Steve

Posted on: 07 December 2014 by Singlespeed

From the horses mouth:

A command in a chip was miss read but cleared once you re started, have you updated the firmware to 3.21?

Regards

Steven Hopkins

Haven't seen this one again as yet.....

Posted on: 07 December 2014 by solwisesteve

Originally Posted by Singlespeed:

From the horses mouth:

A command in a chip was miss read but cleared once you re started, have you updated the firmware to 3.21?

Regards

Steven Hopkins

Haven't seen this one again as yet.....

On 3.23.... as it came from Naim a couple of months ago.

Posted on: 08 December 2014 by Singlespeed

This happened to mine when 3.21 was current firmware. not seen it again since so figure it was just a glitch. Email Steve if you want further nfo....?

cheers

Posted on: 08 December 2014 by solwisesteve

Originally Posted by Singlespeed:

This happened to mine when 3.21 was current firmware. not seen it again since so figure it was just a glitch. Email Steve if you want further nfo....?

cheers

I emailed Naim support but no answer yet.... Fault not seen again. tbh this is my second ND5 so I'm a bit twitchy :-(

Posted on: 13 December 2014 by Singlespeed

Came home to this error today!

Reboot sorted it. Did you get a response from HQ yet?

cheers

Posted on: 13 December 2014 by solwisesteve

Suggestion was a brown out and don't worry about it.... Not seen it since so it might have been something funny on the mains.

Posted on: 13 December 2014 by Singlespeed

Originally Posted by solwisesteve:

Suggestion was a brown out

Yes wifey said we had a couple of them during the day...

System has been playing for 8 hours today so I reckon it'll be ok