UQ and n-Stream - "no devices found"

Posted by: Benji on 13 April 2011

This is most likely a very n00b question, but having recently purchased a UQ, I'm having trouble using the n-Stream app to control the UQ. Setup was easy, I have eyeconnect running on a MacBook Pro and have no problem streaming my music over (although it is slow to load lists and start playback, even on a wifi N network?).

But I digress. The MBP, UQ and my iPhone 4 are all on the same wifi network. But when I try to setup the n-Stream app, it searches and finally tells me "No devices found". I'm running the 2.0 version of the app, and the UQ has firmware 3.0.00, Boot 1.2.03, and BC SW 10733.

Any ideas as to what I'm doing wrongly?

Posted on: 28 April 2011 by Ellsworth

Originally Posted by TJ:

Hi Ellsworth,

In our experience BT home hubs are not the most reliable routers for using in a UPnP application. They seem to sometimes decide to spuriously block UPnP traffic. Also the problems with them vary between wired and wireless and the problems come and go, so you can think you have fixed it then some hours/days later it all stops working again.

Also there are differences between the different vintage Home Hubs, some seem to work better than others, there is plenty of discussion on the subject on the internet.

TBH I would recommend getting rid of the HH and getting as standard WiFi router (Netgear or similar).

Thanks TJ. Ill get a netgear and test that.