Mornin' all,
A couple of weeks ago I invested in a SuperLine E currently powered by the 282. I haven't fully tested all the load plug combinations but have settled for 500/1nF for the moment (cart is the EMT JSD6). Compared to the StageLine it is a huge improvement and I look forward to finding the perfect load combo over the coming weeks.
I picked up a SuperCap 2 DR (2014) pre-loved for what I hope is a pretty good price (45% off new) and I will collect this Saturday morning - very excited about that!
some questions
- I have kind of run out of space in my rack - is it ok to stack a HiCap and the TT power supply directly on top of the SuperCap? Or the 250 on the SC? Or is this not recommended?
- Are there any specific load combos you would recommend on the SuperLine? I have read elsewhere on the forum that the 470 is a good choice - should I order one and how much do the cost roughly?
As ever your insights are welcome and appreciated
Sten
Posted on: 15 July 2016 by yeti42
Naim supplied me with a Z plug just over a year ago, at least on the second time of asking, the first one turned out not to have Z foil resistors when we checked but it came back with them after we'd sent it off for a change in value.
Posted on: 15 July 2016 by kuma
That's great. So all Airplug supplied from NAUK have Z plug now? or you have to specify?
How did you find out if the first one did not have Z foil resistors?
Posted on: 16 July 2016 by yeti42
I ordered a 120 Ohm Z plug through my Naim dealer (Simon) to use with the Proteus after trying a few combinations but later decided 100 Ohms was better. Simon suggested the value of my airplug could be changed and opened it up, there were 2 blue cylindrical resistors in it, Simon didn't comment at the time but sent it back to Naim for 100 Ohm exchange and it returned with Z foils in place. I wasn't charged for the value change as I'd ordered a Z plug in the first place. Whether Naim offer both and sent the wrong one or it was a mistake and Z foil is what you should get by default in an airplug now I don't know.
Posted on: 16 July 2016 by Sten
Picked up the SuperCap and the Burndy - all good the superLine connects to the SuperCap via burndy!
But I assume I will need a din 4 to din 5 to connect the SuperCap to the 282 - have I understood that correctly or do I connect the Superfine to the 282?
Sorry but got myself a bit confused
Thanks
