Naim logo

Posted by: grahambateman on 14 January 2017

guys.

hope you can help.

i gave dac ,150 qwwx and flatcap. 

All the naim logos are at different brightness  with 2 ire so amost dark. Is there a fix for this. Yes i know it's not a big problem bus cosmetically hmmm.

thanks

graham

Posted on: 14 January 2017 by JamesN

Hi Graham,

Funnily enough I have my NAP 200 booked in next week with a Naim dealer to have the logo changed to a less bright one so it matches my 202 and Hi Cap. Don't think it will be too expensive. I think they said around £40. 

James

Posted on: 14 January 2017 by joerand
grahambateman posted:

i gave dac ,150 qwwx and flatcap. 

All the naim logos are at different brightness  with 2 ire so amost dark. Is there a fix for this. Yes i know it's not a big problem bus cosmetically hmmm.

I tried the Bing translator but it was no help. Interestingly, it detected your post as English.

Posted on: 15 January 2017 by Richard Dane

The early half moon logos were quite a bit brighter - too bright in fact, so this was toned down in around 2002 with the introduction of the new classic/ reference kit. Replacement logos are available to purchase via your Nsim dealer. You will need to ask them for the cost of logo and fitting.

Posted on: 15 January 2017 by HiFiman

My NAP100 logo is probably twice as bright as my 272

Posted on: 15 January 2017 by HiFiman

Following Richards post maybe all the old pre 2002 logos were dug out from the Naim basement and installed in the NAP100s

Posted on: 15 January 2017 by Richard Dane

There will be some variance from model to model and to a lesser extent sometimes from sample to sample, but nothing like the difference between pre and post 2002, which is glaringly obvious. 

Posted on: 15 January 2017 by bluedog
Richard Dane posted:

There will be some variance from model to model and to a lesser extent sometimes from sample to sample, but nothing like the difference between pre and post 2002, which is glaringly obvious. 

I see what you did there