4.6 firmware update problems

Posted by: gsr on 11 April 2018

Trying to install new firmware but when I try to install the driver software from this link (http://www.silabs.com/Support%...210x_VCP_Windows.zip), I keep getting the following error message :

"device driver installation wizard was unable to find any drivers designed for your machine"

The computer (PC) is linked to the Uniti 2 by a mini USB cable and the device is on.

Any ideas or suggestions would be much appreciated.

Thanks

Gordon

Posted on: 11 April 2018 by GraemeH

You need to save the zip to your machine and then ‘Extract’ and run the exe...I know because I did exactly like you yesterday before being rescued!

Good luck,

G

Posted on: 11 April 2018 by gsr

Thanks Graeme, Working now!

Posted on: 11 April 2018 by GraemeH
gsr posted:

Thanks Graeme, Working now!

Knowledge transfer from ‘FinkFan’ & ‘HifiMan’...I was clueless before they intervened!

Glad it’s working.

G

Posted on: 11 April 2018 by gsr

done the factory reset and have the following fault come up - Fault 61 BridgeCo init fail

Any ideas?

Posted on: 11 April 2018 by GraemeH

Switch off for a minute then power back on - seems to resolve the issue.

G

Posted on: 11 April 2018 by Huge

Turn it off, leave a few min then turn on again.  This sometimes works.  Try another reset if you can.

Posted on: 11 April 2018 by gsr

Once again thanks Graeme. Working now!

Posted on: 11 April 2018 by GraemeH
gsr posted:

Once again thanks Graeme. Working now!

G