Remote handset doesn't... after factory reset ..(do anything)

Posted by: rjstaines on 02 May 2018

I just updated the firmware in my NAC N272, and like a good Naim user did a factory reset at the end... and now my remote handset no longer talks to the 272. My NDS handset now talks to both the NDS and the 272, which is a tad unfortunate to say the least (one would like to control them separately, not in sync !)

I posted about this 2 years ago, but what I wrote then wasn't enough detail to solve today's problem and I've slept since then (and forgotten completely). Does anyone know how to re-sync the remote with the device ?

Thanks,

Roger

Posted on: 02 May 2018 by hungryhalibut

Try this...

https://forums.naimaudio.com/to...t-a-unitiqute-remote

Posted on: 02 May 2018 by rjstaines

Thanks HH, that's it. The important thing is to turn off the unit then turn it on and while the start up logo is displayed press and hold Aux, info, 5 (or 4 or 3 or 2 or 1). That's the bit I'd forgotten.