A quick speaker cable related question (but NOT one about which to buy!)
Posted by: CraigP on 05 February 2003
New to Naim so please excuse a possible silly question, but from reading the archives there seams to be a lot you can do to maximise your sistem without spending anymore money:
I have a Naim Nait 3 which is sat on a Quadraspire table with a CD5 on the shelf above. I purchased 2 x 4m of NACA5 which is far more than was required, but i wanted to exceed the 3.5m min length, so the rest of the speaker cable is wound in S bends and NOT carefully shoved under the bottom shelf on the floor in a general mess. Is the insulation on the NACA5 sufficient that there would be no interference from the 2 channels of wire being all criss-crossed together, or should i attempt to seperate the cable into 2 distinct lots?? (it may make no difference but for a small job if it made an improvement then great).
Also i have ordered a new Headline and NAPSC, can these sit on my shelf on top of the Nait 3, or would this also cause interference of some kind??
Thanks in advance
Craig
I have a Naim Nait 3 which is sat on a Quadraspire table with a CD5 on the shelf above. I purchased 2 x 4m of NACA5 which is far more than was required, but i wanted to exceed the 3.5m min length, so the rest of the speaker cable is wound in S bends and NOT carefully shoved under the bottom shelf on the floor in a general mess. Is the insulation on the NACA5 sufficient that there would be no interference from the 2 channels of wire being all criss-crossed together, or should i attempt to seperate the cable into 2 distinct lots?? (it may make no difference but for a small job if it made an improvement then great).
Also i have ordered a new Headline and NAPSC, can these sit on my shelf on top of the Nait 3, or would this also cause interference of some kind??
Thanks in advance
Craig