Problem with Stageline Connected to NAC282 + NAPSC + 2 x Hi Cap + NAP250

Posted by: endlessnessism on 09 April 2016

I have recently upgraded from a Nait XS + Hi Cap to a NAC282 + NAPSC + Hi Cap + NAP250.

All has been good for a few weeks now but so far I have only been using digital sources via a DAC.

This morning I decided to crank up my LP12. With the Nait XS + Hi Cap, I had the LP12 connected via Stageline into "Aux2 In & Power" and all was good. Now, however, with the Stageline connected to "Aux2 In & Power" on the NAC282, I am getting a signal from the LP12 but the volume is very very low,

The light on the Stageline is showing so it is powered-up OK.

Any suggestions for what might be wrong? Have I made a mistake in assuming that Stageline is compatible with the upgraded system?

Posted on: 09 April 2016 by The Strat (Fender)

Stageline with 282 perfectly compatible - well mine was.

Sorry for stating the obvious but worth checking the phonos into the stageline.

Regards,

Lindsay

Posted on: 09 April 2016 by Christopher_M

Can the two different Aux2s be independently selected with the remote? Is it possible that the non powered Aux2 is selected? Clutching at straws....

Chris

Posted on: 09 April 2016 by AlanJ

Aux2 can be mapped to the phono ports on the rear if 282. Check your manual. This may be your ussue.

Posted on: 09 April 2016 by AlanJ

Hold prog key to enter program mode then toggle the 6 key to select/deselect phono socket for Aux2.

Had reverse problem when my 282 came back from its recent service.

Excuse typos....hate iPhone keyboard

Posted on: 09 April 2016 by endlessnessism

All good now as per Alan's advice. Thanks for the prompt responses.