Nait 1

A 90 will not run those speakers properly but will work as would an early Nait

I'd look for a 160 or a 180

Richard Dane posted:

I'd hold out for a NAP110.  Be patient.  Plenty about, you just need to wait and keep your eyes open.

I'm not very patient.

Patience pays off as you'll be able to find a good one - too many cosmetically shabby (panel lettering yellows), modified, serviced by a mate up the road who's good at soldering examples about so worth waiting 

Very good 110's are scarce as are 160's

140 & 180 much easier to source down, not a bad amp, virtually similar apart from a larger PSU trafo in 180.

Amp boards and electrolyts etc are same thing, in my 180 the amp board are written Nap 140"

Allthough a 72 would match better visually a 32 is fine IMO

Several NAP180s on a well known auction site, at least one of them recently serviced.

Foot tapper posted:

Several NAP180s on a well known auction site, at least one of them recently serviced.

They are not CB are they, I can get a Nap140 from Italy for €300 shipped, is this ok?

If in good condition and not modified in any way, then yes.  If recently serviced by Naim or an authorised service centre then it's a bargain.  

You can always order a genuine Naim UK power cable from your Naim dealer for about £15-20, if memory serves me well.

Gurbinder posted:

Foot tapper posted:

Several NAP180s on a well known auction site, at least one of them recently serviced.

They are not CB are they, I can get a Nap140 from Italy for €300 shipped, is this ok?

180 olive only

140 CB or olive

Nearly there.

32.5 bought

HICAP bought

NAP140 on route from Italy

Uniti 2 BT sold

Guys my system is finally coming together just waiting on the Nap140.

I just wanted to comfirm the wire up sequence.

32.5 into Hicap.

Hicap into Nap140.

????

Gurbinder posted:

Guys my system is finally coming together just waiting on the Nap140.

I just wanted to comfirm the wire up sequence.

32.5 into Hicap.

Hicap into Nap140.

????

Correct