Naim connections

Have a look here Vince.

https://www.naimaudio.com/site...ation%20Rev%201J.pdf

Stu

Vilco! Bloody spellcheck!

stuart.ashen posted:

Vilco! Bloody spellcheck!

You know that, within 15 minutes of posting, you can actually edit a post.

Connect socket 4 on the Hicap to the 5 pin socket on the 62, using a 5 pin snaic cable. You need to remove the little round link plug from the socket on the 62. The band on the cable goes at the 62 end. Connect socket 3 on the Hicap to the 150, using a 4 pin snaic cable. The band on the cable goes at the Hicap end. 

You cannot use the flatcap. 

I hope that makes sense. 

Ok perfect.

I do not understand which one  the little round link plug from the socket on the 62.

Thank You

If you wanted to use the 62 without a Hicap this would mean connecting the 62 to the 150 with a 4 pin snaic lead, and you would need a link plug in the 5 pin socket on the 62. But as you are using a Hicap the link plug must be removed. If you don’t have one, it has been removed already. With the Hicap in use, there is no direct connection from the 62 to the 150. The signal goes from the 62 to the Hicap and then to the 150.

Is that ok?

everything is clear to me now
practically until now, I have always used the nac 62 connected directly to final (outpup pre - input Final) and at the same time I used the 5 pin snaic cable from the nac 62 to socket 4 Hicap.
I hope I have not done any damage.
Thanks for everything

If it all works when you plug it in correctly:

62 -> HiCap -> 150

then there's no damage and you're OK.

It should sound a bit better.