Naim Unitiqute 2 speakers

Much better to solder than to crimp to NACA5.  For a UnitiQute, use these...

Here's a picture a member has previously posted on here of what they look like under the housing, soldered to NACA5...

Ardbeg, your brother could have a rather nice performance upgrade for very little outlay...

Richard Dane posted:

Much better to solder than to crimp to NACA5.  For a UnitiQute, use these...

Here's a picture a member has previously posted on here of what they look like under the housing, soldered to NACA5...

Ardbeg, your brother could have a rather nice performance upgrade for very little outlay...

Thanks for the suggestion, is a good idea for a birthday present.

Phantom speakerwire from Witchhat in UK is pretty good vfm and excellent performance on Naim kit

Some of employees are previous Naim engineers

Expect some delivery time if you order, my Phantom took 6-7 weeks but was an introduction so perhaps understandable, the interconnect took even longer but a misunderstanding or two might have caused delay.

Hi. I used to run Focal Aria 906 with my UQ2 - great combo imo. Didn't like Naca5 on UQ2, but you might, so it's worth a shot. I used DNM Reson speaker cable, and the Nap 100 was a worthwhile addition. The Dynaudio, Neat Iota at the very least are good suggestions, but depends on positioning - the Emits need space, the Iotas are great for shelf  or wall mounting, but you'll miss some bass with those.

Just to chip in re Guru. You can deal direct as I did re QM10 stands. In addition I found NAC5 superior in all respects when uniti 1 driving QM10.