Which cable?

Posted by: robgr on 04 December 2016

I have the following NAC272/NAP250DR/XPSDR/C20s with SL cables

I'm adding an Anthem MRX520 for A/V, I've connected the rear C1s with NACA5 (long run so cost was a factor)

What would an appropriate interconnect be to take the MRX520 pre-outs back to the NAC for the fronts

My thoughts are that SL or VERTERE ACOUSTICS might be overkill, what about Tellurium Q Graphite?

Any other suggestions?

Posted on: 04 December 2016 by Finkfan

I'm a big fan of the TQ cables. The graphites are very good cables. The ultra black are close to them. The black diamonds are better again. As you already use Naim cables have you thought about a HiLine? You could get an rca to din.

Posted on: 04 December 2016 by Adam Zielinski

At this level I would stop at around HiLine level. So RCA to DIN HiLine or Chord Signature.

Posted on: 07 December 2016 by blythe

I use Chord to connect my Anthem MRX710

Posted on: 09 December 2016 by Wals79

I use chord shawline to connect throughout my naim inc processor to 200 for front channels i also use chord epic twin sp cable to my ears it sounds awesome